Initial Software Setup
First Time Setup
when unboxing and using cincraft scenario for the first time, an initial “first time setup” is required the first time setup does the following actions configure internet connectivity download and install any mandatory software updates check for any optional software updates register the cincraft origin hardware with a cincraft account registering the origin with a cincraft account is a requirement for licensing the system and must be done if intending to use the system in a production environment hardware registration can be skipped, this will allow the user to use the system in reduced mode upon restarting the origin, the user will be invited to conduct the hardware registration again this section describes the first time setup and hardware registration as a pre requisite ensure that a cincraft account has been created and that you have the login details required https //www cincraft zeiss com https //cincraft zeiss com/us/home press “ start initial setup start initial setup ” to begin the hardware registration process it is mandatory to have an active connection to the internet, from the subsequent page, connect a wired internet connection into the lan port of the origin, or alternatively enter wifi credentials via the “network configuration” button once an active internet connection is detected then you will be able to proceed to the next step the cincraft system will check for any updates, some updates are mandatory, and these are unable to be skipped once any optional or mandatory updates have been downloaded then you will be able to proceed to the next step to begin the hardware registration process, click the “ start registration start registration ” button this will display a 6 digit “ registration code registration code ” and instructions to log into your cincraft portal account from another device on a separate device, navigate to cincraft zeiss com and log into your cincraft account from the panel on the left hand side, select “ device registration device registration ” page from the scenario section on this page enter the 6 digit registration code optionally give your system a name naming a system is not mandatory but can help with identifying a system when multiple hardware is attached to a single cincraft account press “ register now register now ” the system will now bind the origin to the cincraft account once the hardware has been registered, cincraft scenario will report this as being completed successfully additionally, the device can now be seen on the “device and license management” tab of the cincraft portal at this stage, the first time setup process is complete, and you can continue setting up and using the system